12:45

Internal fixation of midshaft clavicle fracture using Synthes superior clavicle plate surgical technique

Overview

Subscribe to get full access to this operation and the extensive Shoulder & Elbow Surgery Atlas.

SUBSCRIBE


Learn the Internal fixation of midshaft clavicle fracture using Synthes superior clavicle plate surgical technique with step by step instructions on OrthOracle. Our e-learning platform contains high resolution images and a certified CME of the Internal fixation of midshaft clavicle fracture using Synthes superior clavicle plate surgical procedure.

Clavicle fractures are common accounting for around 2.6% of all fractures, with middle third fractures accounting for 80%. 2-6% occur in the medial third, while the remaining 12-16% occur in the lateral end of the clavicle. These fractures most commonly occur in a young and active population.

The management of such injuries can be controversial as historically, displaced mid-shaft clavicle fractures have been managed conservatively with low reported non-union rates. However, more literature has reported much higher rates, up to 20% on occasion. It is widely accepted that this can be reduced significantly with surgical intervention.

Whilst there is some risk with any surgical intervention, the published results also demonstrate that  plate and screw fixation can be performed safely to give a good outcome with improved patient satisfaction and a reduction in the non-union rate compared to conservatively managed fractures.

For displaced lateral end clavicle fractures, there is a higher rate of non-union and therefore, the threshold for surgical fixation is lower. Options for surgical fixation include specific lateral end anatomic clavicle plates utilising a variety of locking screw options for the smaller lateral fragment. Some plates allow reconstruction of the ruptured coracoclavicular ligaments with a non-absorbable material to augment and support the repair. If standard internal fixation is not possible due to comminution, these fractures can also be managed with a hook plate. The lateral end of this plate hooks under the acromion and butresses the lateral clavicle from displacing superiorly. The disadvantage with this type of fixation is that it needs to be removed once the fracture has healed to avoid impinging on the rotator cuff and causing a cuff tear. Whilst in situ, it may also physically limit the arc of movement in the shoulder.

There are many implant companies with clavicle specific plates. My preference is for the Synthes LCP clavicular (Locking Compression Plates). These are anatomically contoured and sided plates with either a superior or supero-anterior plates option for mid-shaft clavicle fractures. Superior clavicle plates tend to require less contouring. Theoretically, the medial screws are also directed further away from the neuro-vascular bundle. The plates and screws on the Synthes set are made of stainless steel with the “combi-hole” design allowing the option of either locking or non-locking screws within the same hole. The Synthes clavicle set also provides useful instruments to facilitate the surgical exposure and fracture reduction.

Author: Mr Sam Chan, FRCS (Tr & Orth).

Institution: The Queen Elizabeth hospital, Birmingham, UK.

The Operation

  • Please ensure you have read the all the information for this operation before starting the test.
  • Each question has four possible answers of which one is correct.
  • You will need to answer all questions before they are marked.
  • You do not need to spend a minimum time on any question.
  • You need to answer all questions before you can submit the paper.

It is strongly advised you go over the operation content, click below to do so:

Internal fixation of midshaft clavicle fracture using Synthes superior clavicle plate



  • Did you find this technique helpful?
  • YesNo

Accreditations

Logo Logo Logo Logo Logo Logo

Associates & Partners

Logo Logo Logo Logo Logo Logo