Stryker MAKO Express Workflow total hip replacement (using Accolade II and Tritanium implants)
Subscribe to get full access to this operation and the extensive Hip Surgery Atlas.
Learn the Stryker MAKO Express Workflow total hip replacement (using Accolade II and Tritanium implants) surgical technique with step by step instructions on OrthOracle. Our e-learning platform contains high resolution images and a certified CME of the Stryker MAKO Express Workflow total hip replacement (using Accolade II and Tritanium implants) surgical procedure.
The MAKO robot was first used in 2010 for a total hip replacement(THA). In 2015 FDA approval was granted and its use since then has increased dramatically. Whilst THA is a very successful operation, there continues to be an potentially reducible incidence of early failure from dislocation and malpositioning of components. The MAKO system has been designed by Stryker to increase the accuracy of component positioning, as well as sizing and it is hoped the longevity of lower limb joint replacement. Other systems are in their infancy at present and the Stryker MAKO is arguably the most common system currently used.
Stryker describe both an enhanced and express “workflow” for the MAKO total hip replacement. The express technique uses the MAKO technology to prepare the acetabular component and the enhanced technique assists with the femoral neck cut, broach version and combined component ante-version as well as acetabular preparation. The express workflow is a quicker surgical technique and focuses on accurate acetabular placement.
The MAKO technique requires a pre-operative CT scan of the patients pelvis and axial slices through the patients knee (to identify the epicondylar axis) and ankle. Using the information from this scan, exact sizing and positioning of the implants can be achieved. Intra-operatively a haptic arm from the MAKO robot is utilised to perform parts of the procedure such as acetabular reaming and cup placement. Intra-operatively the surgeon has real time feedback on the component position, leg length and hip offset.
If the surgeon is unhappy intra-operatively with any element of the MAKO plan (such as cup size, inclination, version), it can be immediately adjusted and the implantation executed to the new parameters. For instance if the planned cup anteversion doesn’t look correct in relation to the patient’s native transverse acetabular ligament, the version can be increased or decreased and the cup repositioned to suit the intra-operative findings.
It is vitally important that the position of the markers and arrays, which are applied to the operated limb and used for the robotic guidance, are not disturbed or adjusted during surgery as this will lead to inaccuracies unless re-calibration is performed.
Author:Mr Richard Baker MD, MSc, MB.ChB, FRCS (Tr & Orth).
Institution: The Avon Orthopaedic Centre, Bristol, UK.
- Please ensure you have read the all the information for this operation before starting the test.
- Each question has four possible answers of which one is correct.
- You will need to answer all questions before they are marked.
- You do not need to spend a minimum time on any question.
- You need to answer all questions before you can submit the paper.
It is strongly advised you go over the operation content, click below to do so: